EMS and usbmass.exe problem
Posted: Fri Dec 02, 2016 8:56 pm
I need to load EMS (EMM386.exe) and USBMASS (proprietary usb 2.0 driver) on this harddrive-less Pentium 1 computer.
With ems, while usbmass.exe loads, when I check my usb stick dir, instead of the list of files, all I see is "IO.SYS" and nothing else.
So I guess this has to do with emm386 and how it is using some part of the memory that usbmass.exe needs, because without ems, usbmass.exe works fine.
The usbmass.exe allows one to define the start address of i/o pool and the start address of memory pool, the help page says:
/IO:n start address of I/O pool (default 0x00002000)
/M:n start address of memory pool (default 0x000D0000)
What parameters should I pass to either emm386.exe or usbmass.exe to get them both working at the same time?
With ems, while usbmass.exe loads, when I check my usb stick dir, instead of the list of files, all I see is "IO.SYS" and nothing else.
So I guess this has to do with emm386 and how it is using some part of the memory that usbmass.exe needs, because without ems, usbmass.exe works fine.
The usbmass.exe allows one to define the start address of i/o pool and the start address of memory pool, the help page says:
/IO:n start address of I/O pool (default 0x00002000)
/M:n start address of memory pool (default 0x000D0000)
What parameters should I pass to either emm386.exe or usbmass.exe to get them both working at the same time?